Tag Archives: seal cylinder block

Seal castings worked upon – Edgar T Westbury’s design

Posted on 26 September, 2009 by Mike Freeman

Today I managed to drill, then tap the oil filler holes on both cylinder blocks of the Seal engines.  The set up time for any machining  task is normally much longer that the metal removal and today’s task was a fine … Continue reading →

Posted in General engineering posts, seal engine build | Tagged , | 2 Comments

Trouble boring the Seal casting……..

Posted on 10 January, 2009 by Mike Freeman

I needed to bore two 1 1/8th holes at either end of the main cylinder block casting on the Seal 15cc 4 cylinder engine. So it would be a simple job of bolting the block to the angle plate on … Continue reading →

Posted in General engineering posts, General posts, IC model engines, seal engine build | Tagged | Leave a comment