Work Starts again – Seal cylinder liners started

100_3552

Drilling out the liner

Drilling out the liner

With the outside turned to size the cast iron is then drilled out to 0.5" before changing to a boring bar

Bookmark the permalink.

2 Responses to 100_3552

  1. Jack Ratliff says:

    Hey there! I hope you don’t mind but I decided to post your website: http://mikes-models.com/blog/index.php/2010/01/work-starts-again-seal-cylinder-liners-started/100_3552/ to my on-line directory website. I used, “Work Starts again – Seal cylinder liners started 100_3552 – http://www.mikes-models.com blog” as your website headline. I hope this is fine with you. In case you’d like me to change the title or perhaps remove it completely, e-mail me at Zangger4783@gmail.com. Thanks for your time.

  2. Mike Freeman says:

    No problems as far as I am concerned.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

Follow Me